INNOVIA PROFESSIONAL SIGN FRAMES - Supplemental Parts and Tools
| Parts for adding sign topper | Qty/Sign | Supplier | Estimate Cost |
| 3/16" x 1 1/4"long Stainless Steel bolt | 2 | Home Hardware | $0.40 |
| 3/16" Stainless Steel Wing Nut | 2 | Home Hardware | $0.40 |
| 3/16" x 1" Stainless Steel Washers | 4 | Home Hardware | $0.80 |
| Small Nylon Tie Wraps | 2 | Home Hardware | $0.06 |
| Tools Needed (one time purchase)* | |||
| 2" x 3" x 37 1/2" lumber - for making template to drill holes. | Scrap Lumber | $1.00 | |
| 1/2" Wood hole cutter - used one time to make template (using the lumber above) for drilling holes in the ground. | Home Hardware | $5.00 | |
| Cordless hammer drill (on sale) - used for drilling holes | Canadian Tire | $90.00 | |
| Masonry Drill bit - 1/2" x 16" - used for drilling holes in ground whether ground is frozen or full of stones. | Home Hardware | $16.00 | |
| 3/16" Wood/Metal Drill Bit - used only if adding a sign topper such as SOLD. | Home Hardware | $5.00 | |
| Pliers w/wire cutter - used to press leg pins into place and to cut off excessive tie wrap material. | Home Hardware | $5.00 | |
| Hammer - used infrequently only if debris falls back into holes after drilling them. | Home Hardware | $10.00 | |
| Canvas easel bag - 40" long, 3" wide, 6" deep for carrying sign frame components and the vinyl sign | Office Depot | $15.00 |
* Chances are that you will have most of the tools mentioned above so extra cost is minimal.